Make Your Own Barbell Collars
fitness·@tara-bich·
0.000 HBDMake Your Own Barbell Collars
  ## Ever get tired of having to thread this thing in to secure your weight?  __I've designed a collar [here](https://www.thingiverse.com/thing:2813000) based off the collars one would often see for an Olympic bar.__  _(Don't mind the ugly sanded areas, I was having some trouble with the support structures for the print...)_ First off, this collar is assembled from four different parts. To assemble you just snap the part onto each other as shown. _Recommended Order_     _sorry for the potato quality..._ __To disassemble__  Hold the collar like so, and push part 1 into part 2 while keeping the collar in its most open position.  _(I originally made this model a single whole piece, through I found it too much of a pain to remove the supports, and to spray the part)_ __Now printing this alone should do the job well enough, but if you want a tighter hold, I recommend following what I had done.__ After printing I recommend getting some spray on rubber to apply to the inside of parts 1 and 2 as shown below.  You can tape up areas that shouldn't have the rubber coating like I had, and follow instructions on your selected spray to apply to the part. I had used flex seal, but I'm sure any other rubber coating spray or liquid should do. After it has dried you should be left with a capable collar to secure your weights.   _(50 lbs / 22.6 kg)_ With this set up, one can also reapply the rubber coating/ add more coats, when the previous coat wears down. Also one can add a thick coat or scale the whole collar down in a slicer for a tighter hold. Do take note, the smaller it is the more stress will be put on the collar. # PLEASE TAKE NOTE Not every bar is the same, the bar I had created this collar for is 25 mm (0.98 inches) in diameter. The size of the collar unaltered in the file holds a tight grip on these 25 mm bars. I have another bar which is closer to 24.5 mm and this collar doesn't fit it as well as it does the 25 mm one, it's too loose. That being said I recommend measuring the diameter of your particular bar before printing out the collar. Using simple math you can then find the percent difference between your bar and mine and scale the parts accordingly. For example: Your bar is 24.5 mm in diameter. 24.5 is 98% of 25, so I would scale the parts down by 2% for a nice fit for that particular bar. If you don't like math then another solution would be to just add an extra thick coat of rubber to your collar, though I haven't tried this for myself yet. Now I'm not a professional or anything so take caution when using this, I don't wan't anyone to get hurt. But for the while I've been using the collar its worked well for me so far. Also if you find any issues with the collar, or have any suggestions feel free to voice them, or modify the model yourself. [The model is publicly available on Onshape.](https://cad.onshape.com/documents/37e85e7eb9ce89b2ebd196d8/w/61ce0b097ccc23bd71f145d9/e/943b613703)